Reference number
Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006
International Standard
Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006
Rolling bearings — Static load ratings
Edition 3
2006-05
Read sample
Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006
38101
Published (Edition 3, 2006)
This publication was last reviewed and confirmed in 2020. Therefore this version remains current.
This standard has 1 amendment.

Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006

Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006
38101
Language
Format
CHF 96
Convert Swiss francs (CHF) to

Abstract

Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006 specifies methods of calculating the basic static load rating and the static equivalent load for rolling bearings within the size ranges shown in the relevant Ïã¸ÛÁùºÏ²Ê¿ª½± standards, manufactured from contemporary, commonly used, high quality, hardened bearing steel in accordance with good manufacturing practice and basically of conventional design as regards the shape of the rolling contact surfaces.

Calculations carried out in accordance with Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006 do not yield satisfactory results for bearings in which, because of application conditions and/or internal design, there is a considerable truncation of the area of contact between the rolling elements and the ring raceways. The same limitation applies where application conditions cause deviations from a normal load distribution in the bearing, for example misalignment, preload or extra large clearance or where special surface treatment or coatings are used. Where there is reason to assume that such conditions prevail, the user should consult the bearing manufacturer for recommendations and the evaluation of the static equivalent load.

Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006 is not applicable to designs where the rolling elements operate directly on a shaft or housing surface, unless that surface is equivalent in all respects to the bearing surface it replaces.

Double-row radial bearings and double-direction thrust bearings are, when referred to in Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006, presumed to be symmetrical.

In addition, guidelines are given for static safety factors to be applied in heavy loaded applications.

General information

 Amendments

Amendments are issued when it is found that new material may need to be added to an existing standardization document. They may also include editorial or technical corrections to be applied to the existing document.

Amendment 1

Edition 2017

Ïã¸ÛÁùºÏ²Ê¿ª½± 76:2006/Amd 1:2017
69102
Language
Format
CHF 18
Convert Swiss francs (CHF) to

Life cycle

Got a question?

Check out our Help and Support

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)