Reference number
ϲʿ 11119-3:2020
International Standard
ϲʿ 11119-3:2020
Gas cylinders — Design, construction and testing of refillable composite gas cylinders and tubes — Part 3: Fully wrapped fibre reinforced composite gas cylinders and tubes up to 450 l with non-load-sharing metallic or non-metallic liners or without liners
Edition 3
2020-11
Preview
ϲʿ 11119-3:2020
75817
недоступно на русском языке
Опубликовано (Версия 3, 2020)
В данный стандарт внесены 1&Բ;поправка.

ϲʿ 11119-3:2020

ϲʿ 11119-3:2020
75817
Язык
Формат
CHF 173
Пересчитать швейцарские франки (CHF) в

Тезис

This document specifies minimum requirements for the material, design, construction and workmanship, manufacturing processes, examination and testing at time of manufacture for:

— type 4 composite fully wrapped cylinders or tubes with a non-load sharing liner and composite reinforcement on both the cylindrical portion and the dome ends;

— type 5 fully wrapped cylinders or tubes without liners and with a test pressure of less than 60 bar and composite reinforcement on both the cylindrical portion and the dome ends;

— water capacities up to 450 l;

— for the storage and conveyance of compressed or liquefied gases;

— cylinders and tubes with composite reinforcement of carbon fibre, aramid fibre or glass fibre (or a mixture thereof) within a matrix;

— a minimum design life of 15 years.

Cylinders and tubes manufactured and tested according to this document are not intended to contain toxic, oxidizing or corrosive gases.

This document does not address the design, fitting and performance of removable protective sleeves.

NOTE 1 References to cylinders in this document include composite tubes if appropriate.

NOTE 2 ϲʿ 11439 applies to cylinders intended for use as fuel containers on natural gas vehicles and ϲʿ 11623 covers periodic inspection and re-testing of composite cylinders.

Общая информация

  •  : Опубликовано
     : 2020-11
    : Опубликование международного стандарта [60.60]
  •  : 3
  • ϲʿ/TC 58/SC 3
    23.020.35 
  • RSS&Բ;обновления

&Բ;Изменения

Поправки принимаются, когда обнаруживается, что в существующий документ по стандартизации необходимо добавить новый материал. В них также могут быть включены редакционные или технические исправления, которые необходимо внести в существующий документ.

Amendment 1

Версия 2023

ϲʿ 11119-3:2020/Amd 1:2023
85413
Язык
Формат
CHF 18
Пересчитать швейцарские франки (CHF) в

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)