Reference number
ϲʿ 12176-1:2017
International Standard
ϲʿ 12176-1:2017
Plastics pipes and fittings — Equipment for fusion jointing polyethylene systems — Part 1: Butt fusion
Edition 4
2017-06
Preview
ϲʿ 12176-1:2017
67803
недоступно на русском языке
Опубликовано (Версия 4, 2017)
Последний раз этот публикация был пересмотрен в  2023. Поэтому данная версия остается актуальной.

ϲʿ 12176-1:2017

ϲʿ 12176-1:2017
67803
Язык
Формат
CHF 129
Пересчитать швейцарские франки (CHF) в

Тезис

ϲʿ 12176-1:2017 specifies the general characteristics of, and performance requirements for, equipment for butt fusion jointing of polyethylene (PE) piping systems using electrically powered heater plates.

ϲʿ 12176-1:2017 is applicable to mechanical and pressure-activated equipment for butt fusion jointing of PE pipes and fittings either intended to be used for the supply of gaseous fuels, conforming to ϲʿ 4437‑2[1] and ϲʿ 4437‑3[2], or intended for the conveyance of water for human consumption (including raw water prior to treatment) and for the conveyance of water for general purposes, conforming to ϲʿ 4427‑2[3] and ϲʿ 4427‑3[4].

Butt fusion machines with an automatic controller are subject to additional requirements as given in Annex A.

NOTE This document is also applicable to butt fusion machines for larger nominal pipe diameters and nominal wall thicknesses than given in this document.

Общая информация

  •  : Опубликовано
     : 2017-06
    : Подтверждение действия международного стандарта [90.93]
  •  : 4
  • ϲʿ/TC 138/SC 4
  • RSS&Բ;обновления

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)