Ссылочный номер
ϲʿ 15590-1:2009
ϲʿ 15590-1:2009
Petroleum and natural gas industries — Induction bends, fittings and flanges for pipeline transportation systems — Part 1: Induction bends
Версия&Բ;2
2009-11
В время отменен
ϲʿ 15590-1:2009
45121
Отозвано (Версия 2, 2009)

Тезис

ϲʿ 15590-1:2009 specifies the technical delivery conditions for bends made by the induction bending process for use in pipeline transportation systems for the petroleum and natural gas industries as defined in ϲʿ 13623.

ϲʿ 15590-1:2009 is applicable to induction bends made from seamless and welded pipe of unalloyed or low-alloy steels. These are typically C-Mn steels or low-alloy steels that are appropriate for the corresponding level and grade of line pipe in accordance with ϲʿ 3183.

ϲʿ 15590-1:2009 specifies the requirements for the manufacture of two product specification levels (PSL's) of induction bend corresponding to product specification levels given for pipe in ϲʿ 3183.

ϲʿ 15590-1:2009 is not applicable to the selection of the induction bend product specification level. It is the responsibility of the purchaser to specify the PSL, based upon the intended use and design requirements; see also ϲʿ 3183:2007, Introduction.

ϲʿ 15590-1:2009 is not applicable to pipeline bends made by other manufacturing processes.

Общая информация

  •  : Отозвано
     : 2009-11
    : Отмена международного стандарта [95.99]
  •  : 2
  • ϲʿ/TC 67/SC 2
    75.200 
  • RSS&Բ;обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)